|
|
|
|
RLM (Remote Lamp Mount) UV-C Series |
 |
Since the introduction of fan coil and heat pump products, persistent issues have been chronicled about the production of musty smells (dirty socks), overflowing drain pans, stained and/or destroyed ceiling panels or room equipment. And because they're often located in difficult to access areas, cleaning, maintaining or replacing these units has been a big challenge.
The RLM UV-C Series of products address these and other concerns. Immediately upon installation, UV-C energy from the RLM Series goes to work photo-dissociating ionic, covalent and dimerized bonds of microbes, dirt and slime -- helping to rid surfaces of these efficiency robbing compounds to keep coils, drain pans and plenums clean. This helps prevent troublesome mechanical problems and associated poor IAQ.
The RLM provides everything needed to maximize the benefits of UV-C, and at the lowest price. Components are a snap to install and they include a high efficiency power supply, a wire harness constructed of state-of-the-art components and a long-life lamp that meets "government required" low waste content, that also surpasses today's environmental standards.
The RLM, available with 12" 22" and 33" sizes, provides everything needed to maximize the benefits of UV-C for PTACs, heat pumps and fan coil units. |
|
UVC Sterilizing System In AHU Cooling Coil |
In this application UV Resources RLM UV-C series of products are
arranged and installed in front or behind the cooling coil of each AHU
(Air Handling Unit). The Lamps are arrayed in such a way as to give
maximum irradiance to the cooling coil surface. They are mounted on
aluminum frames and are powered remotely from a control box housing the
ballasts and sensor boards. This control box is mounted outside the
AHU, out of the air stream.
This is a customized solution and each AHU requires one control box
and an appropriate number of lamps, depending on the size of the AHU.
Each lamp has a set of dry contact signal that can be linked to a Building
Management System for monitoring purposes. |
 |
- The UVC Control Box is mounted on the
side of the AHU. The power supply to the UVC control box should be interlocked to the AHU so that when the AHU is shut down, so will be the power to the UVC control box.
- Box is splash proofed.
- LED indicators to show lamps in operation.
- ON/OFF switch for emergency
- Dry contacts for Building Management System (BMS) application
|
 |
| |
DEF UV-C SERIES |
 |
The DEF (double ended fixture) UV-C Series provides everything needed to maximize UV-C benefits in HVACR systems for every use at the lowest price. The DEF UV-C Series comes in both standard output (SO) UV-C and high output (HO) UV-C to meet the needs of any HVACR application. The DEF UV-Series SO products can be used in any setting, including HVAC cooling coils and filters, to control the growth of mold, its byproducts and airborne pathogens including tuberculosis (TB) and other common HVAC airborne pathogens.
Both the DEF SO and HO products come in two sizes and can be assembled in any combination to meet the width of any plenum or target surface.
The DEF SO UV-C Series has been designed to bathe surfaces including HVAC cooling coils and filters with UV-C energy to control and stop microbial growth. These microbes include but are not limited to Cladosporium, Aspergillus niger, Penicillium and Rhizopus.
|
|
|
|
|
|
